| NOTES |
1: |
Boldface loads are maximum for the Load
Index shown. |
| 2: |
For shipping purposes, tire inflation
pressures may be
increased to 30 psi (210kPa).
Inflation pressure must be adjusted to correct operating
inflation before
operation. |
| 3: |
At higher transport speeds (above 20 mph) and lower pressures (less than 12 psi) increased inflation pressure may be required for vehicle stability. |
| 4: |
When running lower
inflation pressures, it
is extremely important to use an accurate air pressure
gauge. |
| 5: |
The above loads are also
applicable to
equipment, including hillside combines, operating on slopes
above 11°
(20% grade). Load adjustments below 20 mph (30 km/h) in the adjoining table do
not apply when operating on slopes greater than 11°
(20% grade). |
| 6: |
For hillside operations, earthmoving operations, and
for moldboard
plowing with single drive wheel tires in the furrow, consult tire
manufacturer for inflation pressure recommendations. |
| 7: |
For cyclic loading field
service, see
Table F-1. For tire sizes not shown, see Note 3 on Table F-1.
|
| 8: |
For transport service and
operations which
do not require sustained high torque, the table to the right
applies. |
|
| MAX.
SPEED |
%
CHANGE IN ABOVE
|
CHANGE IN INFL.
PRESSURE |
| Statationary |
+189% |
+6
PSI (40kPa) |
| 10
MPH / 15 KM/H |
+34%
(except hillside combines) |
NONE |
| 15
MPH / 25 KM/H |
+11%
(except hillside combines) |
NONE |
| 20
MPH / 30 KM/H |
+7% |
NONE |
| 25
MPH / 40 KM/H |
NONE |
NONE |
| 30
MPH / 50 KM/H |
NONE |
NONE |
|
| FOR RIM AND
WHEEL LOAD INFORMATION, SEE IMPORTANT NOTES IN CHARTS I
AND II IN GENERAL FARM TIRE INFORMATION |
|